Inconsistent peer vlan Problem in Switches - Cisco Community Inconsistent peer vlan SW0 1 -3650#sh spanning-tree summary Switch is in pvst mode Root bridge for: VLAN0001, VLAN0010-VLAN0011 SW01-3650#sh run int g1 0 23 Building configuration Current configuration : 89 bytes ! interface GigabitEthernet1 0 23 description SW02 switchport mode trunk end ----- SW0 2 -3750X#sh spanning-tree summary Switch
Solved: Inconsistent Peer VLAN ID - Cisco Community I'm having some trouble trying to figure out why I'm getting the following errors in my logs This morning, for the first time in over a year, my switch stopped communicating with my core switch, so I checked the log Feb 27 16:25:15 364 UTC: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsi
Received BPDU with inconsistent peer when adding VLAN Inconsistent local vlan 004971: Jun 30 11:15:27 826 CET: %SPANTREE-SW1-2-RECV_PVID_ERR: Received BPDU with inconsistent peer vlan id 401 on Port-channel116 VLAN1000
%SPANTREE-2-BLOCK_PVID_PEER: Blocking Inconsistent peer vlan Hello Comunity! Spanning Tree %SPANTREE-2-BLOCK_PVID_PEER: I know there are a lot of posts about inconsistent peer VLANs being blocked But in my situation, both switches are in the same mode "Switches are in Rapid PvST mode", all VLANs are allowed on the trunks, and both switches have the same VLANs
Port Channel Load Balancing Issue – Inconsistent Output Interface The `port-channel load-balance internal` command on Nexus 9k switches configures internal load balancing within port channels, and its default value dynamic load balancing might influence traffic distribution In your scenario, where vPC-connected switches forward packets of the same flow via different interfaces, this could result from dynamic load balancing To ensure consistent egress paths
Inconsistent peer vlan and Inconsistent local vlan This makes Nexus complaining about inconsistent peer vlan and Inconsistent local vlan In short, I need to "translate" vlans 31,32,33 into vlan 21 Vlan translation 1-to-1 won't work as I can't add multiple entry with same translated vlan Vlan translation n-to-1 won't work as it makes QinQ (as far as I get it from documentation)
%Inconsistent address and mask - Cisco Community Our ISP has set up a modem at our location with the following IP and subnet: ip 96 74 187 50 mask 255 255 255 252 I'm trying to put in an ip route to the next hop which is our firewall switch> ip route 96 74 187 50 255 255 255 252 10 10 22 5 when I do this I get %inconsistent address and mask We wer